WOW in Bromley

Trace & Access Leak Detection in Bromley

WOW supports domestic & commercial enquiries in Bromley involving hidden leaks, plumbing faults, heating systems, drainage, HVAC & mechanical services.

Reasons to contact WOW

Common reasons customers contact WOW

1

Boiler losing pressure without a visible leak

2

High water bills or meter movement when outlets are closed

3

A damp ceiling below a bathroom

4

Foul smells from a waste, soil or drainage system

5

Recurring drainage problems requiring a CCTV survey

How faults are narrowed down

Different faults require different tests

Leakage linked to flushing, showering or appliance discharge is investigated while the relevant fixture is used; ordinary drainage is not described or tested as a sealed pressurised service.

The reported timing & system behaviour are considered together so that a suspected cause is not presented as confirmed without supporting evidence.

Fixture & drainage related leakage is checked during controlled use, with accessible joints observed & dye, flow testing, a boroscope or CCTV selected where each method is appropriate.

Specialist leak detection process

What happens during a leak investigation in Bromley

1

Confirm the symptom

We establish where water has been noticed or whether the boiler or sealed heating circuit is losing pressure, when the problem occurs & which fixtures or systems are operating at the time.

2

Map the affected area

Accessible components are inspected & moisture meter readings are used to map the spread. A thermal camera may identify temperature patterns, but thermal imaging is not treated as proof on its own.

3

Separate possible sources

Cold water supplies, hot water services, sealed heating circuits, fixtures, wastes, drainage & condensate routes are considered separately. Pressure loss refers only to the sealed heating circuit; hot water services are checked for leakage or performance faults.

4

Test the relevant system

Depending on the evidence, checks may include meter monitoring, staged isolation, pressure testing of suitable supply pipework or a sealed heating circuit, controlled fixture use, dye testing or CCTV inspection. Ordinary drainage is tested during discharge, not as a pressurised service.

5

Narrow the source area

Acoustic listening equipment, tracer gas & boroscope inspection may be introduced where the pipework & conditions suit those methods. No single instrument reading is relied upon without supporting evidence.

6

Explain the findings

The results are compared & explained, including any limitations. Targeted access is recommended only where the evidence supports a particular route or source area, & repair or access work is quoted separately.

Questions answered

Bromley leak detection FAQs

How would WOW investigate ceiling staining after a shower or bath is used in Bromley?

The relevant fixture is operated under controlled conditions while accessible traps, seals, wastes & joints are observed. Dye or flow testing may be used to confirm the route, & CCTV is considered only where an inaccessible drainage section needs internal inspection.

How long does a leak detection survey usually take?

Please allow approximately 2–3 hours on site for a complete leak detection survey, including up to 2 hours of pressure testing where appropriate. The time varies with the number of systems requiring checks, available isolation points & whether the fault occurs during the visit. Very slow or intermittent losses may require monitoring, staged isolation or a further agreed test before a reliable location can be confirmed.

How much does leak detection cost in Bromley?

A complete leak detection survey is £500 + VAT from 8am–5pm, £600 + VAT from 5pm–9pm & £700 + VAT after 9pm. Tracer gas is included where required. Repair or access work outside the survey is quoted separately.

What happens if WOW cannot find the leak?

WOW's No Find, No Fee policy applies where a genuine active leak is within the agreed investigation but its source cannot be identified during that investigation. Terms apply. Rising damp, condensation, building defects & other non leak causes are excluded because the specialist testing has still been completed. Where evidence is limited or the fault is intermittent, the findings & the most appropriate next step will be explained without claiming an unsupported location.

Will floors, walls or ceilings need to be opened?

Not automatically. The objective is to narrow the source before opening a surface. If the combined test results support a particular pipe route, fitting or source area, targeted access may be recommended for confirmation & repair. Excavation, access work, repairs, materials, waste removal & reinstatement are not included in the survey price & are quoted separately before work proceeds.

What happens before targeted access is recommended?

WOW compares the visible damage with the route of nearby supply, heating, hot water, waste & drainage services. The relevant system is then isolated, monitored or operated using suitable diagnostic equipment. Targeted access is recommended only when the combined evidence supports a particular pipe route, connection or source area; opening up may still be required for final confirmation & repair.

Contact WOW about a suspected leak in Bromley

Explain what is happening & when it changes. WOW will confirm the relevant service, current availability & applicable price when you contact us.

Other London service areas: Edmonton, Woodford, Walthamstow. View every service area.